US engine management manufacturer AEM Electronics have just announced the release of their new Infinity 6 and Infinity 8h ECUs. These ECUs share the same advanced features as their range topping Infinity 8/10 while offering a smaller physical footprint, the simplicity of a single 80 pin connector and a more competitive price point.
The Infinity 6 is ideally suited to 4 cylinder or 6 cylinder engines, while the Infinity 8h is perfect for 8 cylinder engines with high impedance injectors. Despite a smaller physical package, the infinity 6 and 8h still benefit from the same advanced 200 MHz/400 MIPS processor used in the Infinity 8/10. The new 6/8h can be purchased with a ‘flying lead’ harness that is pre-wired for power, ground, a power relay and fuse block, or a connector and pin kit if you would prefer to construct your own harness.
Infinity 6/8h Features:
Volumetric Efficiency (VE) based tuning model
ECU Set Up Wizard to simplify startup
Flex-Fuel compatible
Drive by wire throttle support
Variable cam control support
Multiple boost control strategies
Nitrous control
Map switching
Internal wideband controller
Dual knock control
Data logging up to 64 GB with up to 100 channels at up to 1 kHz
Support for aftermarket dashes and data loggers
High speed data transfer (up to 480 Mb/sec)
Engine protection strategies
IP67 rated sealed enclosure
Check out a video about the AEM Infinity here
Comments
No one has commented on this page yet.