Sale ends todayGet 30% off any course (excluding packages)
Ends in --- --- ---
Forum Posts
Courses
Blog
Tech Articles
Hi, I am tuning a VR6 engine with EMU Black and I am trying to figuring out why my cam angle is moving even with all the table
disabled, cam anglet target is at 0 and control type is on "none", I can't find anything else that could control my cam angle and make it move,
sometime it is at 32° and sometime at 0.
During a pulls it always move to 0° at around 4200rpm
Here is the log/tune
Attached Files
377hhp.emublog
