Sale ends todayGet 30% off any course (excluding packages)
Ends in --- --- ---
Forum Posts
Courses
Blog
Tech Articles
Ask questions about webinar lessons here. To see the Previous Webinars for a complete list of archives tuning webinars.
= Resolved threads
I have an ecumaster black and I noticed then when you pulled up the 3d idle ref table...it was 3d with the clt temp on the x axis and the idle target on the y.
My software only shows this table as a 2d table leaving out the RPM target. Though I dont think it's critical as I can monitor the target and actual RPM through the log and other means, I am wondering if I am missing some type of configuration on my software that you may have?
Thanks in advance,
Michael
you mean your page doesnt look like this ? if nt maybe try upoading the latest software as this was how it was when i loaded the software
https://www.dropbox.com/s/6rr8onx6qgknbv2/Screenshot%202021-04-22%2022.02.26.png?dl=0
Regards Ross
Hi Ross,
It does look like the screen shot you provided. However, in the webinar the table was 3D.
This confirms I have the latest software. Thanks.
